10-09-2006 08:56 AM - edited 07-04-2021 01:16 PM
I have a WLC 4402 that I am using in a wireless testbed. During the initial configuration, I followed the basic configuration guidelines for the L3 LWAPP. Tried to configure the Service-port without an IP(0.0.0.0), but it would not accept it(msg."Service Port Address cannot be set to 0.0.0.0").
Currently, I am running code 3.2.116.21.
Has anyone come across this issue?
Thanks,
Chris
10-09-2006 10:04 AM
I have generally given the service port an IP, even if I don't plan to use it. You could always give it something you will never use like 10.255.255.1 or something similar.
10-09-2006 12:04 PM
Ethiel,
Thanks for the info. I have already done this. Just wanted to know if there was another way around it.
Best Regards,
Chris
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: