Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC 4402 Management Interface

I am in the process of installing a 4402-12. It's being connected to a HP Procurve GB PoE switch.  The Management and AP Manager are untagged.  2 VLANS were created 201 (SECURE) and 221 (GUEST).  HP switch has VLAN 1 disabled with no native VLAN being used.  Only VLAN currently being used on HP switch is 201. It was my intention to allow complete access to anyone using SECURE while I would redirect all GUEST traffic onto on HP port to a DMZ.  When I connect the management and both AP mgr ports (LAG) I have a HTTPS connection to the management interface and it can also be pinged.  As soon as I tag or trunk the AP manager interfaces (or physically remove the AP manager cables) the management link drops and I no longer have any access to the 4402?  It's as if the 4402 is using the AP Manager interface to connect to the Management port.  Why?

1 REPLY
New Member

Re: WLC 4402 Management Interface

Figured it out.  Was thinking that the management port and service port were the same where in reality the management port is virtual and the physical service port has no purpose at this time.

603
Views
0
Helpful
1
Replies
CreatePlease login to create content