WLC 4402 multiple VLAN to single SSID. Is it possible?
We have 100 remote sites and our initial WiFi design was to use a unique VLAN for wireless clients at each remote site and map the corporate-wide SSID to the unique VLAN at each site.
This would require mapping one SSID to multiple VLANs on the 4402. Is this possible? It looks like the 4402 supports a 1-to-1 mapping only between SSID and VLAN. If this is true we will have to re-think our design and perhaps create a large single network (ie. 10.17.0.0/16).
Re: WLC 4402 multiple VLAN to single SSID. Is it possible?
What you can do on the controller is setup the SSID to be "locally switched" and use HREAP. HREAP is supported on the 1130, and the 1242 AP's at this time. This will allow you to have the same SSID and corporate, and remote sites, but when you associate you are locally switched. Here is a link to the HREAP deployment guide.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...