WLC 4404 brick, what can i do?

[denis_kondrashov]

Hello!

Yesterday's power off. After turning on the controller wlc 4404 does not boot.

On the console, we get the following:

Net:

PHY DEVICE  : Found Intel LXT971A PHY at 0x01

FEC ETHERNET

IDE:   Bus 0: OK

  Device 0: not available

  Device 1: not available

Booting Primary Image...

Press <ESC> now for additional boot options...

Error (no IRQ) dev 0 blk 0: status 0x51

Error reg: 10

** Can't read from device 0 **

** Unable to use ide 0:4 for fatload **

Error (no IRQ) dev 0 blk 0: status 0x51

Error reg: 10

** Can't read from device 0 **

** Unable to use ide 0:4 for fatload **

bzImage Image Integrity Check Failed(Bad Magic Number). Hanging

Apparently damaged flash. I have new CF256Mb.

There are ways to recover?

[Leo Laohoo]

Do you have a valid Service Contract to RMA the appliance?

[denis_kondrashov]

No End User havn't Service contract.

[Scott Fella · Accepted solution]

Then there isn't much you can do, because you would probably have to RMA it. I think they are end of support also so you wouldn't be able to purchase a support contract.

Sent from Cisco Technical Support iPhone App