Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC 5508 w/ 1042s - Initial Configuration Question

I have to do an install from scratch and was looking for some basic suggestions for the configuration. I have a 5508 that I have to tie into 6509.

I have to stand up 16 - 1042 model APs.  I'll be supporting numerous clients - barcode scanners, phones, iphones and laptops with WPA2.  I will have to build 2 WLANs - one for DATA and for a hotspot.

Does anyone have a base configuration they can share for both the WLC and the 6509 configuration?  Does anyone have a "from scratch" build process doc they could share?  Does anyone have a recommended code version ?

I've downloaded the 7.0 Configuration Guide but was hoping to get some real world guideance also.

TIA,

Amir

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: WLC 5508 w/ 1042s - Initial Configuration Question

Hi,

Well, starting from the version, 7.0 is the latest so it is good to start from it.

Initial set up of 5508:

http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70mint.html.

I would advise you to read carefully this section where explains the details, and best practice to configure the WLCs ports and interfaces.

Regarding config guides, I would advise you to go through the design guide:

http://www.cisco.com/application/pdf/en/us/guest/netsol/ns279/c649/ccmigration_09186a00808d9330.pdf.

And the configuration examples:

http://www.cisco.com/en/US/products/ps6366/prod_configuration_examples_list.html.

They are valid for all models of WLC.

They are the basis of the configuration and very good examples.

HTH,

Tiago

--

If  this helps you and/or answers your question please mark the question as  "answered" and/or rate it, so other users can easily find it.

2 REPLIES
Cisco Employee

Re: WLC 5508 w/ 1042s - Initial Configuration Question

Hi,

Well, starting from the version, 7.0 is the latest so it is good to start from it.

Initial set up of 5508:

http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70mint.html.

I would advise you to read carefully this section where explains the details, and best practice to configure the WLCs ports and interfaces.

Regarding config guides, I would advise you to go through the design guide:

http://www.cisco.com/application/pdf/en/us/guest/netsol/ns279/c649/ccmigration_09186a00808d9330.pdf.

And the configuration examples:

http://www.cisco.com/en/US/products/ps6366/prod_configuration_examples_list.html.

They are valid for all models of WLC.

They are the basis of the configuration and very good examples.

HTH,

Tiago

--

If  this helps you and/or answers your question please mark the question as  "answered" and/or rate it, so other users can easily find it.

New Member

Re: WLC 5508 w/ 1042s - Initial Configuration Question

Thanks Tiago for the doc links.  I'll review them shortly.

2887
Views
0
Helpful
2
Replies