WLC 5760 - AP2600i failed to join ap-group after reboot
We're deploying a couple of 2600i with an WLC 5760.
We've configured an AP group, named it "factory", and then issued the command ap name AP<ip mac address> ap-groupname factory for both APs. After the restart, both AP were on the AP-Group factory.
The problem is that is we reboot or power off the APs, one will join automatically the AP-Group factory and the other goes to default-group and requires the ap name APAPf872.ead7.31da ap-groupname factoryto join the AP group factory again.
Any suggestion? Is it possible to forced the ap-group configuration directly on the cli of the AP?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...