Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WLC 5760 Controller with 3702 AP

Install Base :

WLC 5760 Controller 

AP 3702I Indoor AP & 1500 Series Outdoor AP connected to 3650 PoE Switches.


AP are unable to show SSID Configured, some AP are showing as joined and few have not joined with critical condition.

AP LED Status showing GREEN-OFF-RED

AP are ordered with correct regulatory domain.

Checked with show log :

 *%CAPWAP-3-POST_DECODE_ERR: 1 wcm:  Post decode processing failed for Config status from AP

*%LWAPP-3-VENDOR_PLD_VALIDATE_ERR: 1 wcm:  Validation of SPAM Vendor Specific Payload(166) with length=7 failed - AP

*%LWAPP-3-RD_ERR3: 1 wcm:  Invalid regulatory domain (0) sent by AP xxxx.xxxx.xxxx (slot: 1 80211a)



Everyone's tags (1)

What version are you running

What version are you running on the WLC?

New Member

Switch Ports Model          

Switch Ports Model              SW Version        SW Image              Mode
------ ----- -----              ----------        ----------            ----
*    1 6     AIR-CT5760         03.06.00E         ct5760-ipservicesk9   INSTALL


New Member

AP Image  

AP Image  

New Member

What is your APs' country

What is your APs' country code?