Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

wlc 5760 design

I have a new deployement with WLC 5760.

total number of aps are 150 with 4 WLANs.

each WLAN is mapped to a sperate VLAN. I have a couple of design questions:

     - the switchport configuration of the AP will be trunk or access ?

       if access, then port should be memeber of which VLAN ?

     - mobility configuration for single WLC design ?

     - I would like to make two groups in which group 1 will advertise WLAN 1,2 and 3 while the group 2 will advertise only WLAN 4.

       is it possible ?

really apprecite your response.

Regards

1 REPLY
VIP Purple

Re: wlc 5760 design

Hi,

Here is my responses

   - the switchport configuration of the AP will be trunk or access ?

       if access, then port should be memeber of which VLAN ?

5760 only support Local mode APs. So all your AP connected switchports (in access layer) should be configured as access ports. You can put that in a different AP management vlan.

     - mobility configuration for single WLC design ?

You can configure a mobility group name even though no any other controllers.

     - I would like to make two groups in which group 1 will advertise WLAN 1,2 and 3 while the group 2 will advertise only WLAN 4.        is it possible ?

Yes, you can create two AP groups & map these WLANs. Then add APs into these two AP groups according to your requirement.

These posts should give you some reference

http://mrncciew.com/2013/12/16/5760-in-ca-cuwn/

http://mrncciew.com/2013/12/12/getting-started-with-5760/

http://mrncciew.com/2013/12/14/3850ma-with-5760mc/

HTH

Rasika

**** Pls rate all useful responses *****

108
Views
0
Helpful
1
Replies
CreatePlease to create content