Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco Employee

WLC 6.0.188.0 bug

I have recently deployed 4 2100 series controllers with the above code, each controller forces the port speed to 10 half which is obviously a nightmare. Reset the speed either via the GUI or CLI to 100 full and it falls back to 10 half within seconds. Rolling back to the 5.1 emergency image fixes the issue but its inconveenient.

Anybody else seen this, I am waiting for TAC to get back to me as I dont think its the same as CSCta49183 hjb Speed/duplex configuration is not available via the CLI for the WLC which indicates the commands are not available.

Anyone else seen this?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: WLC 6.0.188.0 bug

Someone from Cisco broke the code.  He he he ...

5 REPLIES
Hall of Fame Super Gold

Re: WLC 6.0.188.0 bug

Hi Pete,

Any reason why you don't want to try the older 6.0.182.0 until they can get this fixed?   Someone obviously "broke" this.

Cisco Employee

Re: WLC 6.0.188.0 bug

I had the code 4.0.207 and new it was a good code so wanted to prove the WLC wasnt broke. When you say someone broke it do you mean the code at Cisco or me! LOL its possible wont be the first time. As someone once said if you never break anything your not trying hard enough!

Hall of Fame Super Gold

Re: WLC 6.0.188.0 bug

Someone from Cisco broke the code.  He he he ...

Cisco Employee

Re: WLC 6.0.188.0 bug

Brilliant!!!!! Not sufre how you would code it but its a driver basically!

Just tested again in auto auto both ends works but not ideal!!!!!!!!

Cisco no of the issue!!!!

Cisco Employee

Re: WLC 6.0.188.0 bug

I don't know if TAC got back to you or not with an ID to track, but it is CSCtb60736.

593
Views
0
Helpful
5
Replies