Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Wlc 8510

Is possible to access a wlc8510 through the service port using https (gui access) ?

3 REPLIES
Hall of Fame Super Gold

I'm don't use WLC 8500 but

I'm don't use WLC 8500 but with the WLC 5508, if you configure the Service Port, you can remote into the Service Port if you plug directly into it. 

New Member

Hi Leoi know it is doable on

Hi Leo

i know it is doable on a 5508 - but it doesn´t seem to be working on 8510....

anyone ?

I have a new WLC8510 to

I have a new WLC8510 to configure on my hand an its data ports(2x10G) are not connected to network. Just the service port is connected. In order to access GUI via service port, you should use "config network webmode enable" command. After that, you can access GUI from PCs which are in the same subnet of service port. Because service port configuration does not include default gateway part. Or, you can write a static route to gateway like "config route add 0.0.0.0 0.0.0.0 <gateway of service port subnet>" which supplies to access it from everywhere routable. I'm using it service port only for last three days because of some SFP issues, but I can access to GUI.

131
Views
0
Helpful
3
Replies
CreatePlease login to create content