wlc aaa acounting interval

[veronika.klauzova]

Hello,

I have WLC 5508 in software version 7.2.111.3 and I would like to know, if there is possibility to configure accounting update interval for stop time. Because I have problem with obtaining stop time in accurate time, I received it with delay in about half hour. I know that on cisco switch is possibility to force that stop time and have it in time when user is disconnected.

Thanks for any advance.

prosím
sloveso potešiť,páčiť sa,chcieť,tešiť

AfrikaansAlbanianArabicArmenianAzerbaijaniBasqueBelarusianBulgarianCatalanChinese (Simplified)Chinese (Traditional)CroatianCzechDanishDetect languageDutchEnglishEstonianFilipinoFinnishFrenchGalicianGeorgianGermanGreekHaitian CreoleHebrewHindiHungarianIcelandicIndonesianIrishItalianJapaneseKoreanLatinLatvianLithuanianMacedonianMalayMalteseNorwegianPersianPolishPortugueseRomanianRussianSerbianSlovakSlovenianSpanishSwahiliSwedishThaiTurkishUkrainianUrduVietnameseWelshYiddish⇄AfrikaansAlbanianArabicArmenianAzerbaijaniBasqueBelarusianBulgarianCatalanChinese (Simplified)Chinese (Traditional)CroatianCzechDanishDutchEnglishEstonianFilipinoFinnishFrenchGalicianGeorgianGermanGreekHaitian CreoleHebrewHindiHungarianIcelandicIndonesianIrishItalianJapaneseKoreanLatinLatvianLithuanianMacedonianMalayMalteseNorwegianPersianPolishPortugueseRomanianRussianSerbianSlovakSlovenianSpanishSwahiliSwedishThaiTurkishUkrainianUrduVietnameseWelshYiddish

Detect language » Slovak

Hello

[aqjaved]

config wlan radius_server acct interim-update

To configure the interim update of a RADIUS accounting server of a WLAN, use the config wlan radius_server acct interim-update command.

config wlan radius_server acct interim-update {interval | enable | disable} wlan_id

Syntax Description

interim-update	Configures the interim update of the RADIUS   accounting server.
interval	Interim update interval that you specify.   The valid range is 180 seconds to 3600 seconds.
enable	Enables interim update of the RADIUS   accounting server for the WLAN.
disable	Disables interim update of the RADIUS   accounting server for the WLAN.
wlan_id	Wireless LAN identifier between 1 and 512.

Command Default

Enabled at 600 seconds.

Examples

This example shows how to specify an interim update of 200 seconds to a RADIUS accounting server of WLAN 2:

> config wlan radius_server acct interim-update 200 2

Related Commands

config 802.11a enable
config 802.11a disable
config 802.11b enable
config 802.11b disable
config 802.11b 11gSupport enable
config 802.11b 11gSupport disable
show wlan

For more information and technical knowledge, please check the below link:

Link-1:

http://www.cisco.com/en/US/docs/wireless/controller/7.2/command/reference/cli72commands.html#wp1324639

Link-2:

http://www.cisco.com/en/US/docs/wireless/controller/7.2/command/reference/cli72commands.html#wp1320025