Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

WLC and AIRONET AP1231

Hi everyone, i have a question, i'm trying to configure a WLC 5508 with an access point AIRONET air ap1231g-a-k9, this is possible or the model isn't supported by the WLC?? i read that only LWAP are compatible

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: WLC and AIRONET AP1231

You do need a service contract to download any image.  This is the image you need...

9-9-2013 11-32-25 AM.jpg

If you are able to download this, then you need to convert the ap from autonomous to lightweight.  Here are the directions for that:

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
6 REPLIES

Re: WLC and AIRONET AP1231

It is up to code 7.0. It isn't supported past this rev.

Sent from Cisco Technical Support iPad App

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________
Hall of Fame Super Silver

WLC and AIRONET AP1231

Just to add.... here is the compatibility matrix you should keep handy:

http://www.cisco.com/en/US/docs/wireless/controller/5500/tech_notes/Wireless_Software_Compatibility_Matrix.html

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
Community Member

Re: WLC and AIRONET AP1231

then I only need upgrade to 7.0, the WLC is actualy in 6.0, isn't necesary change autonomous ap to lwapp.? another question. I need a service contract to download software from cisco's page.?

Hall of Fame Super Silver

Re: WLC and AIRONET AP1231

You do need a service contract to download any image.  This is the image you need...

9-9-2013 11-32-25 AM.jpg

If you are able to download this, then you need to convert the ap from autonomous to lightweight.  Here are the directions for that:

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
Bronze

Re: WLC and AIRONET AP1231

you must change the aIOS image to lwapp/capwap ap, which uses k8 image

Sent from Cisco Technical Support iPhone App

Community Member

Re: WLC and AIRONET AP1231

thanks to all, it was helpful, questions answered.

426
Views
15
Helpful
6
Replies
CreatePlease to create content