I have a WLC 2112 and a DHCP server enabled on a Linksys router. I have configured a wireless LAn to have IP address from the Linksys DHCP server but it doesn't work and when i configure anthor DHCP server it work.
Haha, thanks for the rating, even though I didn't do anything :D
5 points for coming back and letting us know what the problem was. I always enjoy learning something new! Sorry that your solution won't work with the LinkSys, though. Maybe you can configure a DHCP service on your switch, rather than purchasing an entire server for it.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...