Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC displays different IP for LAP in GUI

Hi,

I have the following issue with one controller  AIR-WLC2112-K9 with 2 LAP .When I ask the info by GUI for the  the LAPs in  Wireless ----> AP name (click) ---->General the info displayed in "IP config"   does not match, for the field static IP is shown  the IP 172.18.98.2 but the line above "IP address"  shows 156.70.30.5. Controller has IP 156.70.30.3

I verified by console with the command show lwapp ip config and the IP is correct.  172.18.98.2.

any idea?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: WLC displays different IP for LAP in GUI

This is a well-know and well-documented issue of the WLC that you can't set static IP to an LWAP.  I'm using 6.0.188.0 and it's hit-and-miss.  What firmware version are you using?

3 REPLIES
Hall of Fame Super Gold

Re: WLC displays different IP for LAP in GUI

This is a well-know and well-documented issue of the WLC that you can't set static IP to an LWAP.  I'm using 6.0.188.0 and it's hit-and-miss.  What firmware version are you using?

New Member

Re: WLC displays different IP for LAP in GUI

hi  leolaohoo ,

thanks a lot for your info.

version is  5.2.193.0 , is a new one controller....but ver is older than yours.

do you have the cisco's link for this issue??

regards

Hall of Fame Super Gold

Re: WLC displays different IP for LAP in GUI

CSCtb16583

248
Views
0
Helpful
3
Replies