I know that there are very similar diagrams in the mobility guide on L3 roaming, but wanted to put a bit more text around each step and wanted you guys to check if it was correct of if I have got it completly wrong. It is just important to get this bit of the puzzle correct.
Please see the attached jpeg diagram, (can post in Visio if you prefer).
Have I got the text correct in regards to how this works. I am giving our support guys a heads up on this at some stage so would be good for some comments?
Kindest regards as always, and thx for all the help.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...