Well you will have some downtime. To limit the downtime, you might want to upgrade to 184.108.40.206 or a 7.0.x code. If you are on this code already then what you can do is either upload the 4400 config to the 5508 then just swap them out or bring up the 5508 on a different ip address and setup mobility between the two and move all the APs to the 5508 and remove the 4400.
Hi, it would be better to bring up the 5508 on a different IP address and setup mobility between them and move the APs from the 4400 to the 5508.
The option off loding the configurarion of the 4400 to the 5508 i would not do it since it is 2 different platforms and the configuration file may get corrupted or not work as it should, also the 4400 requires AP manager interface mean while the 5508 not and other differences.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...