Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

WLC Redundancy over L3 link

Hi All,

Is it possible to deploy WLC redundancy over L3 link???

In our scenario we have 2 controllers located in 2 different sites, the link between the site is L3. AP's are deployed across four other locations, two are coming to site 1 and rest two are coming to site 2 . How can i make redundancy on this setup , Please advice

Controller is 4404 and AP's are 1231G series .

Regards

Aslam ...

1 REPLY
Hall of Fame Super Silver

Re: WLC Redundancy over L3 link

What is your link between each site? Also, I suppose your ap's are running in H-REAP mode? If you don't have enough bandwidth, then you shouldn't try it. You can always try to move the ap's to either wlc and see if users have any issues or not, before you try to deploy redundancy in this matter.

-Scott
*** Please rate helpful posts ***
187
Views
0
Helpful
1
Replies
CreatePlease to create content