I recently setup some networking monitoring at each of our sites and I'm now noticing that there is a lot of traffic that shows up as going to and from the WLC to AP's. Can it be that our GUEST WIFI is using this traffic since we don't have HREAP configured for it? We usually see traffic directly from our users on our secure WIFI with does use HREAP but nothing from the guest. Is it safe for me to assume that the traffic in our monitoring is from our GUEST WIFI or is it normally for the WLC and AP's to be contantly sending lots of data to and from eachother? It wouldn't be a problem if we only had one site but in our scenario we have a WLC at our head office and all AP's in remote sites are controlled from the WLC at the head office so traffic passes through our WAN links. Is there anyway I can see this traffic from the controller?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...