Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
I am trying to connect a WLC 4402 184.108.40.206 mode with an HP 2800 switch. The switch is configured thunk mode with LACP protocol.
The WLC in LAG mode uses the protocol LACP? How can configure them switch HP?
not supported, Mirko. Refer to this for further detail:
NO Not possible. Can they not do just MODE ON .i.e no negotiation
If not, you have to create individual ap-managers to avoid running into any issues.