10-17-2006 09:09 AM - edited 07-03-2021 01:06 PM
Please help to configure the engine in the IOS 1210 series APs environment.
I tried lot but I could not confgiure the AP in the wlse web console
Please help me
swamy
10-18-2006 12:01 AM
Hi Arumugasamy,
what version of WLSE are you using?
Start with this document to confirm the correct setup of your wireless environment (Wireless comonents, router, switches).
http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cwparent/cw_1105/wlse/2_13/dev_gd/index.htm
And if you chenged some seettings in the WLSE it is better to set the factory defaults:
http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cwparent/cw_1105/wlse/2_13/u_gd/cliadmin.htm#wp1114582
After that - depending on you WLSE Version - you get with the next login a wizard. This wizard helps you to setup the basically needed information.
What information is needed you will find here:
http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cwparent/cw_1105/wlse/2_13/1130-19g/1130cfg.htm
I hope that helps.
Best regards,
Frank
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community