10-17-2006 09:09 AM - edited 07-03-2021 01:06 PM
Please help to configure the engine in the IOS 1210 series APs environment.
I tried lot but I could not confgiure the AP in the wlse web console
Please help me
swamy
10-18-2006 12:01 AM
Hi Arumugasamy,
what version of WLSE are you using?
Start with this document to confirm the correct setup of your wireless environment (Wireless comonents, router, switches).
http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cwparent/cw_1105/wlse/2_13/dev_gd/index.htm
And if you chenged some seettings in the WLSE it is better to set the factory defaults:
http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cwparent/cw_1105/wlse/2_13/u_gd/cliadmin.htm#wp1114582
After that - depending on you WLSE Version - you get with the next login a wizard. This wizard helps you to setup the basically needed information.
What information is needed you will find here:
http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cwparent/cw_1105/wlse/2_13/1130-19g/1130cfg.htm
I hope that helps.
Best regards,
Frank
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: