Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

would someone have a simple config for WLC5508 to be used for site survey?

folks,

looking at doing the site survey before detailed implementation. we plan to use a wlc5508, AP3602, a good tripod/stand, PoE switch and AirMagnet to conduct the site survey. i'm inclined to use a single AP and just a guest SSID and let AirMagnet merge the readings on where i 'locate' the AP (on 1 VLAN)

can someone please send me a config for the WLC to quickly get the AP provisioned? i'm still learning which parts of the GUI are improtant/critical/could safely leave alone.

thanks!

Jose

Everyone's tags (1)
1 REPLY

would someone have a simple config for WLC5508 to be used for si

Jose:

Basic configuraiton is very easy. It is even easier than doing the backup/restore for the config you are asking about

I suggest you go through this link:
http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080665cdf.shtml

Steps for you in a nutshell:
- Configure the management interface. (Controller -> Interfaces). for VLAN tag, use 0 if you are using the native vlan on the switch. otehrwise specify the VLAN number.

- Create a WLAN that mapped to this inerface  (WLANs) and configure its parameters. (interfaces, security...etc).

You are done.

HTH

Amjad

Rating useful replies is more useful than saying "Thank you"
269
Views
0
Helpful
1
Replies
CreatePlease to create content