Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

CISCO ASA FIREWALL 5510

Community Member

Hi All,

please I need your kind help to solve my problem... it was just few days ago I brought a cisco asa firewall 5510 for our office but it sad to say that I cannot able to connect my cctv camera dvr through WAN access it shown in the dvr " upnp failed. please open upnp " even do I enabled already the upnp in my router and open a port number in my cisco firewall 5510 for both tcp / udp

your kind help is highly appreciated

Thanks,

moroako

3 Comments
Bronze

Moroako,

Interesting. You may wish to confirm that your DVR is on the same layer 2 subnet as your inside interface on the ASA in order for UPNP configuration commands flow between the DVR and firewall.

Note that your question is best placed in another support community more appropriate for this topic (not this community, which is for the topic of Intelligent Automation). I suggest opening your inquiry here - https://supportforums.cisco.com/community/netpro/security/firewall and that when you do you'll want to post your question as a "Discussion" rather than "Blog". Discussions are a better mechanism for facilitating a Q&A type of interaction. Good luck!

Community Member

sorry for late reply.. Sir i'm just new in CISCO Firewall Equipment ASA 5510.. here is the flow

of our firewall connection

the Internal Ip addres of my DVR: 192.168.1.29 255.255.255.0

and connected into Firewall ASA 5510 port number : e0/0  ip add 192.168.1.1 255.255.255.0

Firewall CISCO 5510 port number e0/3 is connected into router ip add 192.168.3.1 255.255.255.

your kind advise I'm highly appreciated

Silver

I think your post has ended up in the wrong forum, one which will not provide you the best service for your request.  This support forum allows users to share automation developed for Cisco Intelligent Automation for Cloud.

Perhaps https://supportforums.cisco.com/community/netpro/security/firewall ?

506
Views
5
Helpful
3
Comments