Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Change automation pack type to "Community automation pack"

Hi  ,

we have created a automation pack as licensed  ( i.e.  without clicking the checkbox for "community automation pack") , But now we want to  change that automation pack as community automation pack ,

Is there any way  to change by executing a SQL query against the CIAC DB (TEOProcess)?

We can't effort deleting and re-creating the new automation pack , as there were some dependencies around it .

Thanks

Raj G

2 REPLIES
Cisco Employee

Change automation pack type to "Community automation pack"

You can change things via SQL query but it's not something I would post on a public forum. I know development would prefer we not interact directly with the DB but in this case it might be a have to. However, development probably can help you directly, so you need to open a TAC case to get to them for help.

In answer to your question directly, I have done (via SQL) what you are needing but again it's not something to post publicly.

Please open a TAC case.

--Shaun Roberts shaurobe@cisco.com CIAC Adoption Pilot Engineering Lead
Bronze

Change automation pack type to "Community automation pack"

The only supported method would be to re-create the TAP. That is, remove all objects from the current TAP, delete the original TAP and re-create it as a community TAP. If there are other TAPs that depend on the old TAP, you will need to "Refresh References" in all of those, before deleting the old TAP, but AFTER you have created the new TAP (AFTER because your other TAPs will try to grab objects they need if they do not currently belong to a TAP)

21
Views
0
Helpful
2
Replies