Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CPO Add VM Hard Disk activity is failing to add disk

I am using to “Add VM Hard Disk” to add a disk VM.  I am specifying that the disk be added to Virtual Device Node SCSI 1:0 on a given VM, i.e. SCSI controller 1 and LUN 0. The activity fails because the SCSI controller is not found. In fact the controller is not attached to any disk yet. That is exactly what I was trying to achieve with this activity in CPO, to attach the SCSI controller and add the disk on the controller 1 and LUN 0 as specified in the activity’s input parameter. I can do it manually through VMWare Client without any issues. Once the controller is attached to a disk, the activity works fine. I can then add disk on any Virtual Device Node SCSI 1:1 or SCSI 1:2. Is there a way to automate this using CPO activity without having to add a disk manually using VMware Client? Any suggestion will be greatly appreciated

Thanks

Ayaz

125
Views
0
Helpful
0
Replies