Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

4215 Inline and sniff interface

I have a 4215 that is inline outside our PIX. The bandwidth is 1.54mb. I also have FastEthernet0/1 sniffing (via a SPAN port) the ethernet interface of our WAN router. The Wan routers ethernet int is 100mb. I suspect I am oversubscribing this unit and the analysis engine is missing packets. How can I tell if the sensor is missing packets? Is there a command that will show this to me?

Thank you in advance.

Mike

2 REPLIES
Cisco Employee

Re: 4215 Inline and sniff interface

Actually there is ... "show statistics virtual-sensor" (version 5.x sensors) or "show interface group 0" (version 4.x sensors) will provide all sorts of information. Hope that helps.

New Member

Re: 4215 Inline and sniff interface

What is the counter I should look for?

143
Views
0
Helpful
2
Replies
CreatePlease to create content