Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

4255 not responding

I have a 4255 that I inherited in my new position and after failing to connect via conventional methods (SSH, telnet, IPS Event Viewer) I connected to the console. No response from the device. I cycled the power on the device and the only thing that comes up on the console is "Booting Device, Please Wait..." and nothing follows. Is there any way to hard reset the device to a factory default config if it will not come up to the CLI? TIA for any help

1 REPLY
Community Member

Re: 4255 not responding

System had bad stick of RAM in it...replaced and works fine now

151
Views
0
Helpful
1
Replies
CreatePlease to create content