Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

5512 IPS

I currently have a cisco ASA 5512 with IPS.

I have eth0 connected to my WAN

          eth1 connected to my LAN ( Switch ) 10.0.0.254

I have setup my sensor on 10.0.0.253 which seems to be on the management interface?

Currently i don't use the managment interface for anything but now i have configured this will i have to plug the management interface into my lan?

just confused to how it will check the trafffic as anything coming from the outside ( internet ) wll go via eth0 which goes to eth1 internal?

Don't understand how the management interface will be able to check against attacks? obviously i will be using inline mode.

Thanks

2 REPLIES
New Member

5512 IPS

just to add on the cisco IDM interface is shows Management0/0 assigned virtual sesnor 0 NONE

Then i have portchannel0/0 backplane interface that is assigned virtual sensor 0 VS0

New Member

5512 IPS

ok think i have anwsered my own question.

the management0/0 is just simply i was of giving me access to the IDS. the actual sensor maps to port channel0/0 (backplane) so anything go through the ASA will go via the sensor.

779
Views
0
Helpful
2
Replies