Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AIM-IPS not listing in show inventory

Hi Friends,

The 281 router has been shipped with AIM-IPS module but when i issue the "show inventory" command it doesn't list the AIM-IPS module.

Its not listing show run also.

but in show tech it shows the AIM-IPS module in slot0.

how to get this module working???

plz help

Regards

Ravi

1 REPLY
Bronze

Re: AIM-IPS not listing in show inventory

Perform the following tasks to configure AIM-IPS:

1. Set up the interfaces.

2. Log in to AIM-IPS.

3. Initialize AIM-IPS.

Run the setup command to initialize AIM-IPS.

4. Create the service account.

5. Perform the other initial tasks, such as adding users, trusted hosts, and so forth.

6. Configure intrusion prevention.

7. Perform administrative tasks to keep your AIM-IPS running smoothly.

8. Upgrade the IPS software with new signature updates and service packs.

9. Reimage the boot helper and bootloader when needed.

148
Views
0
Helpful
1
Replies