Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

AIP SSM-10 configuration on ASA 5520

Hi All,

I need to configure IPS module on ASA 5520.

I have assigned ip address to the ips module but not able to access it from the asdm.

8 REPLIES

Re: AIP SSM-10 configuration on ASA 5520

Just open a web-browser and open the AIP-SSM.

https://

I hope you have connected the Ethernet interface to the network and added your admin machine to the list of permitted IPs on the AIP-SSM.

Regards

Farrukh

New Member

Re: AIP SSM-10 configuration on ASA 5520

http://www.cisco.com/en/US/docs/security/ips/6.1/installation/guide/hw_logging_in.html#wp1039632

start at the ASA firewall command line.

session into the IPS module.

config a couple of basics from IPS command line

connect the IPS module ethernet interface to your network

access the IPS with the assigned IP address using either your browser, SSH or telnet.

Re: AIP SSM-10 configuration on ASA 5520

thanks ..

now i able to login to the IPS module throgh ASDM.If any separate license is required for IPS module?

Cisco Employee

Re: AIP SSM-10 configuration on ASA 5520

Yes to be able to use the signature updates. Otherwise the sensor is fully functional with the signature set shipped with the software version you are on.

Re: AIP SSM-10 configuration on ASA 5520

You need the "Cisco Services for IPS" licesne for your AIP-SSM to get signature updates from the internet. However you can do software upgrades when they are released and keep upgrading your AIP to the signature release present in the upgrade. This is not recommended tough.

Regards

Farrukh

New Member

Re: AIP SSM-10 configuration on ASA 5520

From the IPS GUI, you can go to the licensing section (look on left side). You can have the sensor go to Cisco to check on license status or you can manually load the license.

Also note the serial number of the IPS. You can see this from the GUI in the license section or in the monitor section (system information).

Re: AIP SSM-10 configuration on ASA 5520

thanks all,

I have registerd the IPS serial number with cisco and got the license.

One thing I want know where can i get the signature update for IPS?

dileep

Re: AIP SSM-10 configuration on ASA 5520

You can downloaded them from here:

http://www.cisco.com/cgi-bin/tablebuild.pl/ips6-sigup

Regards

Farrukh

1356
Views
18
Helpful
8
Replies