Is it possible for AIP-SSM to see all messages that module generates during boot process? I need to obtain output similar to output that appliance (IPS4345 or other) sends to console session during boot.
I tried executing "debug module-boot 255" in ASA CLI and resetting the module after that, but the output is very short:
Slot-1 12> Cisco Systems ROMMON Version (1.0(11)5) #0: Thu Aug 28 15:23:11 PDT 2008 Slot-1 13> root@caldina:/auto/pixaa/pixab/bootbuild/184.108.40.206/Xpix/boot/rommon Slot-1 14> Platform ASA-SSM-20 Slot-1 15> Launching BootLoader...
I tried the same steps for IPS software module in ASA5515X and received very verbose output (similar to that of IPS4345 sensor).
Is there any file to which module writes its boot log?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...