Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

AIP-SSM Upgrade for ASA Active/ Active

Hi everyone!

I  need some help on upgrading the aip-ssm modules to E4 on two asa s which are active/active state. Will i be able to do this without the downtime?what are considerations ?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: AIP-SSM Upgrade for ASA Active/ Active

The AIPs are independent of the ASA failover, however, the ASA can consider the AIP status in failover switchover, meaning it can failover

if it detects an AIP module going down on the active device.

The best method for upgrade in this situation will be to setup active failover status for all groups on the primary ASA, then upgrade the AIP of the secondary ASA.

Once the AIP of the secondary is completely updated and functional, then set all the groups to be active failover on the secondary ASA.

Then upgrade the Primary AIP.

Once the primary AIP is completely upgraded and working, you can then restore the failover status on the ASAs, by setting failover active for the group on the specific ASAs you want them to be active on..

Regards,

4 REPLIES
Silver

Re: AIP-SSM Upgrade for ASA Active/ Active

The AIPs are independent of the ASA failover, however, the ASA can consider the AIP status in failover switchover, meaning it can failover

if it detects an AIP module going down on the active device.

The best method for upgrade in this situation will be to setup active failover status for all groups on the primary ASA, then upgrade the AIP of the secondary ASA.

Once the AIP of the secondary is completely updated and functional, then set all the groups to be active failover on the secondary ASA.

Then upgrade the Primary AIP.

Once the primary AIP is completely upgraded and working, you can then restore the failover status on the ASAs, by setting failover active for the group on the specific ASAs you want them to be active on..

Regards,

Re: AIP-SSM Upgrade for ASA Active/ Active

I will go with what you say. Thanks for your time

Regards,

Nandan

New Member

Re: AIP-SSM Upgrade for ASA Active/ Active

Do you also have to do this everytime you push a sig update to the AIP's as well?

Thanks

Mike

Silver

Re: AIP-SSM Upgrade for ASA Active/ Active

In general a signature update does not require a reload. So you can independently do signature updates on the modules on each of the pair, and not be concerned about triggering  failover.

This may help clarify what you want to avoid doing if you don't want failover to happen in relation to the modules on ASA:

http://www.cisco.com/en/US/docs/security/asa/asa80/system/message/logmsgs.html#wp5355853

Regards,

1114
Views
0
Helpful
4
Replies