Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Analysis Enginer showing not running

Analysis Engine is not running and giving Error:

Error: getAnalysisEngineStatistics : ct-sensorApp.598 not responding, please check system processes - The connect to the specified Io::ClientPipe failed

3 REPLIES
Gold

Re: Analysis Enginer showing not running

Reboot your IDSM, if you have not done so already. From the router CLI:

hw-module reset X reset (X is the slot number for your IDSM)

This happens after some software upgrades and (fewer) signature updates.

Community Member

Re: Analysis Enginer showing not running

Thanks for your respanse,I have restarted the module and after few days we are getting same error.we are using Intrusion Prevention System, Version 6.2(1)E3. for last one and half years.Is there any bug issue related to this.

Re: Analysis Enginer showing not running

I fixed this issue once using the following procedure:

https://supportforums.cisco.com/docs/DOC-3589

If the above procedure or reload does not fix the issue as suggested on the following link:

https://supportforums.cisco.com/docs/DOC-5121/diff;jsessionid=82FA4EB3696EC0C97B6394F996EEAA5E.node0?secondVersionNumber=2

You have to contact TAC, as mentioned below:

http://www.cisco.com/en/US/docs/security/ips/6.0/installation/guide/hwTS.html#wp1122031

Regards

Farrukh

Message was edited by: Farrukh Haroon

766
Views
0
Helpful
3
Replies
CreatePlease to create content