Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA 5545 NIPS CPU utilization 100%

Hi,

We are having two pair of NIPS SSP and working in Active and standby mode.

All four Devices (ASA 5545 and ASA 5525 SSP IPS) showing CPU utilization 100% on both active and standby devices.

Memory usage is also showing very highly utilized.

Kindly help me resovle this issue.

CPU.jpg

Regards,

Dheeraj


1 REPLY
Community Member

ASA 5545 NIPS CPU utilization 100%

Hi Dheeraj,

I don't think this is an issue. CPU 100% utilization is reported on every IPS (appliance or ASA software module) and it should be normal.

If you want to see if your device is getting more traffic than it can process, you should look at inspection load.

I hope this will help and it would be nice if someone from Cisco team could reply to this.

732
Views
0
Helpful
1
Replies
CreatePlease to create content