Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA AIP-SSM configuration replication

Folks,

Does the AIP-SSM replicate the configuration to other AIP-SSM into ASA/Standby?

I mean, when I change the configuration over the Active AIP/SSM, will that change make replicated to other AIP-SSM?

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ASA AIP-SSM configuration replication

Yes, unfortunately all the IPS is the same. Configuration doesn't automatically replicate from 1 unit to the other.

Please kindly mark the post as answered if you have no further question. Thanks..

3 REPLIES
Cisco Employee

Re: ASA AIP-SSM configuration replication

No, the configuration on tohe AIP-SSM module is independant on both the Active/Standby ASA. You would need to manually configure both the

AIP-SSM module independently, and also with different ip addresses assigned to them.

Hope that answers your question.

New Member

Re: ASA AIP-SSM configuration replication

Hi Jennifer,

thanks for your reply.

Then, the AIP-SSM have the same behavior about IDSM-2, we are buying two modules of the IDSM-2 and I was looking for how to replicate the configurations and I saw that there is no way to do this.

thanks a lot

Cisco Employee

Re: ASA AIP-SSM configuration replication

Yes, unfortunately all the IPS is the same. Configuration doesn't automatically replicate from 1 unit to the other.

Please kindly mark the post as answered if you have no further question. Thanks..

434
Views
0
Helpful
3
Replies
CreatePlease to create content