Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA threat-detection drop rate Messages

Hi,

I have on my ASA threat-detection configured. I see the below in my logs:

[ Scanning] drop rate-1 exceeded. Current burst rate is 10 per second, max configured rate is 12; Current average rate is 7 per second, max configured rate is 10; Cumulative total count is 4557

[ Scanning] drop rate-2 exceeded. Current burst rate is 8 per second, max configured rate is 10; Current average rate is 7 per second, max configured rate is 10; Cumulative total count is 27755

[ Scanning] drop rate-1 exceeded. Current burst rate is 10 per second,max configured rate is 12; Current average rate is 7 per second, max configured rate is 10; Cumulative total count is 4702

[ Scanning] drop rate-2 exceeded. Current burst rate is 8 per second,max configured rate is 10; Current average rate is 7 per second, max configured rate is 10; Cumulative total count is 27835

Previously, the configured rates were lower then the rates that are occuring, so I increased the configured rates to 12/10 and 10/10 but still getting the above messages. Should I adjust the rate-interval as well? And how?

thanks,

Everyone's tags (4)
880
Views
0
Helpful
0
Replies
CreatePlease login to create content