Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Gold

Can't configure IPS Banner via VMS 2.3

The 5.x sensor's allows you to set a login banner with the "banner login" command on the CLI. This fills some legal obligations, but I have not found a way to set this via VMS so that I can push this out to all my sensors in one update. Please tell me VMS can do this. I do not want to configure each sensor by hand, and then have to re-import them all.

2 REPLIES
Bronze

Re: Can't configure IPS Banner via VMS 2.3

Gold

Re: Can't configure IPS Banner via VMS 2.3

That page is part of a usefull set of pages describing how to configure the IPS Sensors using the CLI. In fact, a page from the same family discribes the CLI banner command: http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_configuration_guide_chapter09186a008055df70.html#wp1030697

What I was asking is how to push this configuration from VMS 2.3, so I can set this option at a group level and push it out to 200 sensors in one shot.

153
Views
0
Helpful
2
Replies