I have a Cisco 5520 with the ASA-SSM-10 IPS Module. I am running version 6.1(2)E3. I need a way to whitelist an IP Address from a Security Scanning vendor. The vendor is Control Scan and everytime they try to certify our site it fails because the IPS is killing their connection. Any help woul be greatly appreciated.
I know this question was asked some time ago, but I don't understand the advice that was given. I'm quoting from the a CLI guide here: "Filters work by removing actions from an event. A filter that removes all actions from an event effectively consumes the event."
The question is how to allow a scan from a particular host or hosts and the answer given is to create a filter which will cause the IPS to consume the event?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...