I have an IPS Sensor 4240 working inline with the default settings... I need to do some tests and I need to change it to behave as an IDS. I know that I should configure the port on the swith as a SPAN port to send all traffic to the IDS (that will no longer be inline)....
My question is... what do I need to do in the IPS Sensor to change it to IDS?
The 4240 has 4 ports. One (in-line VLAN pairs) or two (in-line interface pairs) of those ports are being used. If you have a free port, put it in promiscious mode (default) and connect it to a new port on the switch that is aggregating your traffic. Configure the new switch interface as a span destination port. then disconnect your in-line interfaces (restoring traffic via another path of course).
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...