Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Changing time on AIP SSM 10 module.

How can i change the sensors time manually on my AIP-SSM-10 module installed in the ASA 5520 device .. ??

i tried the clock set command but apparently its not supported on AIP-SSM-10 module.

the ASA has the correnct time but the IPS does not...

any ideas ??

thanks..

zaid

2 REPLIES
Bronze

Re: Changing time on AIP SSM 10 module.

AIP SSM can automatically synchronize its clock with the clock in the ASA in which it is installed. This is the default. The UTC time is synchronized between ASA and AIP SSM. The time zone and summertime settings are not synchronized between ASA and AIP SSM. You have to configure the time zone on the SSM because it is the UTC time that it gets from the ASA.

Bronze

Re: Changing time on AIP SSM 10 module.

You can find the complete configuration guide for the AIP-SSM-10 in the URL posted below. The configuration of the time-settings is explained in the following chapter: 'Initial Tasks > Configuring Time'.

http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_configuration_guide_chapter09186a008055df9a.html#wp1035238

Please rate if the post is usefull!

Regards,

Michael

372
Views
0
Helpful
2
Replies
CreatePlease to create content