Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Cisco IME device disconnect

 

Hi,

We are running IME 7.2.7 to manage two sensors modules  IPS01 and IPS02

IPS02 remains connected while IPS01 gets disconnected after sometime.

On IPS01 event status shows 'not connected'  when its highlighted, it suggests to click 'edit' and "apply the settings again"

 

We edit the ips01 device and new certificate gets stored. AND device gets connected.

But after sometime it again gets disconnected and displays same message on the device status as 'not connected'.

What can be the reason for the issue and mitigation for that?

 

Regards,
Gurjit Singh
Network Engineer
Spooster IT Services

 

57
Views
0
Helpful
0
Replies
CreatePlease to create content