CISCO IPS v5 mismatch in between CISCO IOS CLI and CISCO SDM
i've noticed a mismatch in between the configuartion of the cisco IOS IPS through the CLI and the results shown by the cisco SDM v2.5. On my cisco 1841 i've enabled/unretired some signature categories such as Adware/Spyware and Viruses/Worms/Trojans which look as expected from the CLI. When i connect trough the cisco SDM, on the Firewall section, lots of the previously enabled/unretired signatures look disabled/retired. If i re-enable/re-unretire them from the GUI the total amount of unretired signatures shown by the CLI doesn't change.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...