command reference for IPS7

[mlopacinski]

Hello

When can i find command reference for IPS appliance ?

i've found this link:

http://www.cisco.com/en/US/docs/security/ips/7.0/command/reference/cmdref.html

but these are only system commands. I need all commans including signature/engine configuration.

For example: "specify-src-addr-filter"

Where can i find it ? (IOS IPS have much fever commands than IPS7)

Thanx

[rhermes]

You're on the right track, a lot of the IPS sensor's configuration commands are under the "service" command.

http://www.cisco.com/en/US/docs/security/ips/7.0/command/reference/crCmds.html#wp562065

- Bob

[mlopacinski]

Yes, but those commands are not documented. Its not just few commands but about 100 or more. Why ?

Example:

specify-src-addr-filter

user-profiles

never-block-hosts

never-block-networks

communication

trap-destinations

enable-set-get

ip-reassembly-mode

tcp-reassembly-mode

It's just few examples. Do you know where can i find command reference with the above commands ?

Thanx

[rhermes]

Sorry for the regurgitated reference, I think this is more of what you were looking for:

http://www.cisco.com/en/US/docs/security/ips/7.0/configuration/guide/cli/cli_introducing.html

- Bob

[mlopacinski]

I know configuration guide, it's quite good, but it's not command reference. And because of this it's not complete.

I used wget&&grep and did not find this commands:

ip-reassembly-mode

specify-src-addr-filter

Did you ?

I could find MANY more commands which are not in configuration guide (and command reference too).

Why cisco could not make a decent command reference for IPS ?

Thanx