Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

command reference for IPS7

Hello

When can i find command reference for IPS appliance ?

i've found this link:

http://www.cisco.com/en/US/docs/security/ips/7.0/command/reference/cmdref.html

but these are only system commands. I need all commans including signature/engine configuration.

For example: "specify-src-addr-filter"

Where can i find it ? (IOS IPS have much fever commands than IPS7)

Thanx

  • Intrusion Prevention Systems/IDS
4 REPLIES
Gold

command reference for IPS7

You're on the right track, a lot of the IPS sensor's configuration commands are under the "service" command.

http://www.cisco.com/en/US/docs/security/ips/7.0/command/reference/crCmds.html#wp562065

- Bob

New Member

Re: command reference for IPS7

Yes, but those commands are not documented. Its not just few commands but about 100 or more. Why ?

Example:

specify-src-addr-filter

user-profiles

never-block-hosts

never-block-networks

communication

trap-destinations

enable-set-get

ip-reassembly-mode

tcp-reassembly-mode

It's just few examples. Do you know where can i find command reference with the above commands ?

Thanx

Gold

command reference for IPS7

Sorry for the regurgitated reference, I think this is more of what you were looking for:

http://www.cisco.com/en/US/docs/security/ips/7.0/configuration/guide/cli/cli_introducing.html

- Bob

New Member

Re: command reference for IPS7

I know configuration guide, it's quite good, but it's not command reference. And because of this it's not complete.

I used wget&&grep and did not find this commands:

ip-reassembly-mode

specify-src-addr-filter

Did you ?

I could find MANY more commands which are not in configuration guide (and command reference too).

Why cisco could not make a decent command reference for IPS ?

Thanx

465
Views
0
Helpful
4
Replies
This widget could not be displayed.