Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configure IDSM-2 and IPS5.0

We are having 2 IDSM-2 installed in cisco 6509 switch.Pls help me out to configure these 2 modules in my network step by step for detection and prevention.

Thank u.

3 REPLIES
Gold
New Member

Re: Configure IDSM-2 and IPS5.0

Thank u for this.but why 2 nos of IDSM-2 are there that is my question.

They are for redundancy or etherchannel solution i have to use?

also I m very much confused with 2 data ports and 2 management ports of each module..how to configure them?

Gold

Re: Configure IDSM-2 and IPS5.0

If you have dual IDSM-2 modules for etherchannel load balancing, here you go:

http://cisco.com/en/US/products/hw/vpndevc/ps4077/products_configuration_guide_chapter09186a008055df92.html#wp1044800

175
Views
0
Helpful
3
Replies