I think when you install the IDSM in a 6500 you use VLANS. I am thinking about using the blade in a 7606, can you do similar task with interfaces? In other words how to you tell the blade what to look at if there are no vlans?
I am new to the IDS/IPS so any help or comments would be helpfull.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...