Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Console port for IDSM-2

Hi friends,

I am unable to access the main application partition image of IDSM-2.

Even though i can access the maintenence partition of IDSM-2, i can't update the software on the app partition.

I tried gaining console access to the IDSM-2 internal ports in the middle of motherboard. But i see that there are two console ports inside the module: one being PC Console and other being LCP console. Which one do i need to access? Also which cable i need to use to connect to this port? What are the terminal settings supposed to be?

Any guidelines on using these built-in ports will be highly appreciated and helpful. We need some guidance on how to recover the IDSM image in this mode.

Thanks a lot

Gautam

Thanks a lot

Gautam

1 REPLY
Silver

Re: Console port for IDSM-2

This chapter contains procedures that are specific to configuring IDSM-2.

http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_configuration_guide_chapter09186a0080459221.html

370
Views
0
Helpful
1
Replies
CreatePlease to create content