Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Could not apply changes Cisco IDSM-2 via gui (IDM)

Expert,

We encountered issue with applying changes via the IDM but it's ok via cli. Is this a known issue with IDSM? I have attached the system info.

3 REPLIES

Re: Could not apply changes Cisco IDSM-2 via gui (IDM)

You did not mention any details about the error?

Regards

Farrukh

New Member

Re: Could not apply changes Cisco IDSM-2 via gui (IDM)

no any error shown. When you tried to apply changes it doesn't do anything and when you tried to move to another screen, it indicate you need to save the config 1st which we can't.

Re: Could not apply changes Cisco IDSM-2 via gui (IDM)

You just have to click on "Apply Changes" if you made any changes on that tab. The changes will then become applied. Maybe the GUI loaded config became inconstistent, click on the 'Refresh' button to get the saved config and then make any changes.

Regards

Farrukh

182
Views
0
Helpful
3
Replies
CreatePlease login to create content