Is there anyway to edit the order or remove items from being generated?
This is from the help file. However, I am unable to find what is mentioned here.
any help is greatly appreciated. Thanks.
The Configuration view displays the status of all non-distributed database items with the name of the administrator who made the configuration changes. A Details link appears beside each edited configuration item. Click this link to view what modifications were made to the configuration in question. Once you've checked these modifications, you can either go back and change or delete configurations or you can click the Generate button (at the bottom of the page) to distribute all updates. The next time agents poll in, they receive the updated policies.
When I attempt to generate rules I get hit with an error saying "Error 1...complexity 7802 which exceeds the maximum of 7500"
The problem that I am having is that after deleting or combining rules I still need to generate them. But everytime I attempt to generate new rules to officially delete the rules I get hit with the error. So I am stuck not being able to generate any rules.
I did attempt what you had mentioned and I believe that those suggestions would work.
However, when you go to generate your rules they are listed in order 1, 2, 3, 4... and so on. my 1st couple of rules would all add on more complexity points. and the next 50 rules would all remove complexity points.
My guess is that because they are in this order vms is trying to generate the rules in order and then seeing that it is already above the limit and then erroring out.
I didnt know if there was something I could do with out needing to generate the rules or if there was a away that I could clear the queue. I have made numerous attempts to lower this complexity limit however everytime it errors out saying that I am 302 items over.
Thank you for your help on this it is greatly appreciated.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...