Having a problem with rule exceptions created through the wizard. We have created several exceptions in a Webserver - Microsoft IIS rule module to allow certain processes. The rules show as enabled but CSA continues to deny the process and log/send out alerts. Any ideas why this would happen? There are several rule exceptions created and none of them seem to work.
Make sure you do a reset locally on the csa gui, just to be sure. If that doesn't help, you probably didn't get the rule created properly. Can you post the event you still get and the contents of the exception you feel should be catching this ?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...